ABSensor 401 connected to CC debugger

Hello, I’m trying to connect the ABSensor 401 to the CC debugger. I have a problems, I guess that I must use the P3 connector on the ABSensor 401 but I can’t find information about the pinout. I tried some connexion but the CC debugger stay red.

Can you help me, please?

Tiphaine

Yes. The P3 is the pins for CC Debugger.

From the hole to another side, the pins are:

  • GND
  • VCC
  • DC
  • DD
  • RESET

For CC Debugger, you should wire all pins above. You also need wire the pin2 and pin9 for the jTag cable. It will provide the target voltage.

Good luck.

1 Like

Thank you